Bestandssystemen


[Nog niet alle pagina's zijn vertaald.  Dit is een werk van lange adem.  Indien een bepaalde pagina u zeer interreseert maar nog moet vertaald worden, gelieve dan de exacte link naar deze pagina naar ons op te sturen met het verzoek prioriteit te geven aan de vertaling ervan.  Dank u.]

Data CD and DVD discs contain one or more File Systems.
The File System describes where and how on the media the files and folders are located.
A File System is often confused with a TOC but it is not.
The TOC describes the session and track layout of a CD or DVD it does not describe the files and folders.
To understand the TOC better, read the section about the CD/DVD Layout.

In most cases the different File Systems point to the same files and the reason for the different File Systems exists to support as many different Operating Systems as possible.  In some cases however, File Systems DO differ and one File System may for instance contain a driver to be able to read the other File System.

IsoBuster scans for all File Systems it knows and will show them all !
This allows for the user to select the File System he/she requires.
This also provides alternative ways in case one File-System is corrupt but the other one isn't !
This is a very powerful feature of IsoBuster in it's quest to be able to recover 'all' data !

You will recognize a File System as the icon connected to a Track icon in the 'Session and Track layout' of the CD/DVD.

IsoBuster fully supports :

  • ISO9660

    IsoBuster - Bestandssystemen

    The most common File System on all CDs and DVDs is the ISO9660 File System.
    It is however also the oldest and has some major disadvantages such as short file names (8.3) and a directory structure which can only be 8 levels deep.  Because of these limitations it is almost always accompanied by one or more File Systems that don't have these limitations.  However you need it if you want to see the content of the CD in an old DOS mode or an older Mac or Sun system.

    Some mastering application sin against these limitations and allow to master ISO9660 with long file names and more directories deep.  This shouldn't be a problem as of Windows 95 OSR2 but these CDs might cause problems in other systems.
    Of course IsoBuster has no problems with these CDs as well.

    Sometimes this File System mentions for what system the CD was mastered.  IsoBuster shows this with following Icons :
    IsoBuster - Bestandssystemen  SUN
    IsoBuster - Bestandssystemen  MAC

    ISO9660 is recorded in a number of duplicate structures (with different byte order)
    You should also read the section Options \ File System settings as you are able to influence how ISO is interpreted based on these duplicate structures.

  • Joliet 

    IsoBuster - Bestandssystemen

    Joliet is in fact an extension of ISO9660 and in many ways exactly the same.
    Some File System Volume Descriptors are different which allows OS to recognize this File System and prefer it if available.
    Joliet allows long file names and a directory structure which is substantially deeper.

    It will be used automatically (preferred above ISO9660) by Windows 95 or higher.

  • Rock Ridge

    IsoBuster - Bestandssystemen

    Rock Ridge is also an extension of ISO9660 but never really became the standard (Joliet did).
    It was very popular on Commodore CDs and also was a way to allow for longer file names and more directories deep.

    It is not supported by Windows and Windows will use the ISO9660 File System on such CDs

  • Who knows ?

    IsoBuster - Bestandssystemen

    This File System starts with its own Volume Descriptor which has all the characteristics of Joliet but points to all the tables of the ISO9660 File System.

    It is probably supported by Windows as I have only seen it on official Windows installation CDs.  It is always accompanied by Joliet as well and Joliet is preferred above this File-System.

  • CD-i File System

    IsoBuster - Bestandssystemen

    Another File System derived from ISO9660 standard but with some specific differences which prevent an ISO9660 interpreting system to always correctly deal with this File-System.  It only appears on CD-i discs and these discs (besides this unique File System) also have some other 'features' which cause real problems on normal systems.

    CD-i is not supported by Windows 95 or higher.

  • El Torito - Bootable CD/DVD

    IsoBuster - Bestandssystemen

    This is not really a File System, more an extra feature of the ISO9660 File System.
    CDs and DVDs can be made bootable but then the ISO9660 File System needs to be present alongside with the El Torito Volume Descriptor and a Virtual Floppy image.
    By just copying a Virtual Floppy image to a CD/DVD one does not make the CD/DVD bootable !  The File System needs to be setup as well.
    More about this here.

    Bootable CDs and DVDs (or the El Torito standard if you will) needs to be supported by the BIOS of your PC system, not the Operating System.  Older BIOS do not handle Bootable CDs well let alone bootable DVDs.

  • UDF

    IsoBuster - Bestandssystemen IsoBuster - Bestandssystemen IsoBuster - Bestandssystemen

    UDF is the 'new' CD/DVD File System and it is already used in a number of situations.
    There also have already been some major changes, so can you encounter UDF 1.02, UDF 1.5 and UDF 2.01

    - DVD-ROM discs should always contain a UDF File-System, preferably UDF 1.02
    - Packet Written Discs (CD-R and CD-RW), e.g. by Roxio Direct CD or Nero InCD use UDF 1.5
    UDF 1.5 contains mechanisms to be able to append files and to be able to deal with defects on host side.
    - Mount Rainier discs should contain UDF 1.02 again because the drive takes care of defect management.

    UDF 1.02 is supported by Windows 98 or higher if the media is closed and contains a TOC.  
    It is preferred over Joliet and ISO9660 if found.  

    What's the difference between : IsoBuster - Bestandssystemen, IsoBuster - Bestandssystemen and IsoBuster - Bestandssystemen :
    IsoBuster - Bestandssystemen : This is the UDF file system which was found via the normal way, the way it is intended to find and explore a UDF file system, possible the same file system as found by other applications.
    IsoBuster - Bestandssystemen  : This is a recovered UDF file system.  It is assembled by putting all lost but found files and directories together.  Where possible the tree structure is respected, but the files and directories in the root can come from everywhere.  You can find this FS by using the function "Find missing files and folders".
    IsoBuster - Bestandssystemen : This is an old file system.  This once would have been a green (normal icon) but afterwards files were added, altered or removed or the application just decided to write a new file system.  A sequentially written media can contain lots of these and it allows you to go back in time looking at older documents and so on.  You can find these by using the function "Find missing files and folders".

  • HFS

    IsoBuster - Bestandssystemen

    HFS is the Apple Mac file-system.  It is used on all types storage media from Hard Drive to CD and DVD.
    HFS itself is quite old and limited with regards to supported storage space, character-sets etc.
    Windows systems don't support HFS at all.  IsoBuster supports HFS on CD and DVD when the media is inserted in a normal CD/DVD drive.
    Image-files however for other type media (e.g. Floppy, HD, Zip, etc.) are also supported by IsoBuster !

  • HFS+

    IsoBuster - Bestandssystemen

    HFS+ is the modern variant of HFS with support for large storage space, unicode and much much more.

  • IFO/VOB

    IsoBuster - Bestandssystemen

    This is not a true file-system, it is a collection of IFO and BUP files inside an existing file-system, 
    but this collection of files is used as a file-system by many (not all) standalone DVD Video / Audio players.
    This pseudo file-system relies on ISO9660 and more importantly on UDF to find the entry points.

  • SIG (or EXT)

    IsoBuster - Bestandssystemen 

    This is not a real file-system but a flat file-list based on file-signatures, hence the name "SIG" or "EXT" from file-extension.
    This list is created during a scan for missing files and folders.
    More on this here.
  • FAT

    IsoBuster - Bestandssystemen

    FAT is a Microsoft invented file-system that has been around for a long time and it was first used on floppies in the days of DOS.  FAT can be used on random writable media that has internal defect management.  DVD-RAM and BD-RE are such media types, hence why FAT is supported by IsoBuster. FAT comes in three flavours, FAT 12, FAT 16 and FAT 32, all three formats are supported by IsoBuster.  The number (12, 16 or 32) represents the amount of bits that are used to store a cluster address in.  FAT32 is the most commonly used FAT file-system today because media these days is large, hence can contain a lot of sectors and clusters.  Because FAT is used a lot on Hard Drives, Pen Drives / Memory sticks, Jazz and Zip drives, floppies etc., IsoBuster can also open a lot of image files created from such media.


    You may also want to read the section about : Write Applications and File Systems